Cisco Cisco 4404 Wireless LAN Controller Guia Da Instalação

You will need the following tools and information before you can install the controller:

Wireless LAN controller hardware

Controller with factory-supplied power cord and mounting hardware

Network, operating system service network, and access point cables as required

Command-line interface (CLI) console

VT-100 terminal emulator on CLI console (PC, laptop, or palmtop)

CISCO console port cable (RJ-45 to DB-9) and modular adapter (RJ-45 female to DB-9 
female) to connect CLI console and controller

Local TFTP server (required for downloading operating system software updates). Cisco uses an 
integral TFTP server. This means that third-party TFTP servers cannot run on the same 
workstation as the Cisco WCS because Cisco WCS and third-party TFTP servers use the same 
communication port.

Obtain the following initial configuration parameters from your wireless LAN or network 
administrator:

A system (controller name).

An administrative username and password. The default administrative username and password 
are admin and admin, respectively.

A service port interface IP address configuration protocol (none or DHCP).

A management interface (DS Port or network interface port) IP address.

The service port interface and management interface must be on different subnets.

A management interface netmask address.

A management interface default router IP address.

A VLAN identifier if the management interface is assigned to a VLAN, or 0 for an untagged 
VLAN.

Distribution system physical port number

4402: 1–2 for front panel GigE ports

4404: 1–4 for front panel GigE ports

IP address of the default DHCP server that will supply IP addresses to clients.