Cisco Cisco Email Security Appliance C170 Referências técnicas

Cluster Management: This command can be used in all three machine modes 
(cluster, group, machine).

Batch Command: This command does not support a batch format.

In the following example, the 

snmpconfig

 command is used to enable SNMP on 

the “PublicNet” interface on port 161. A passphrase for version 3 is entered and 
then re-entered for confirmation. The system is configured to service version 1 
and 2 requests, and the community string 

public

 is entered for GET requests from 

those versions 1 and 2. The trap target of 

snmp-monitor.example.com

 is entered.  

Finally, system location and contact information is entered.

mail3.example.com> snmpconfig

Current SNMP settings:

SNMP Disabled.

Choose the operation you want to perform:

- SETUP - Configure SNMP.

[]> setup

Do you want to enable SNMP? [N]> y

Please choose an IP interface for SNMP requests.

1. Data 1 (192.168.1.1/24: buttercup.run)

2. Data 2 (192.168.2.1/24: buttercup.run)