Cisco Cisco Email Security Appliance C170 Guia Do Utilizador
33-38
Cisco AsyncOS 9.5 for Email User Guide
Chapter 33 System Administration
Alerts
Example Alert Message
Adding Alert Recipients
The alerting engine allows for granular control over which alerts are sent to which alert recipients. For
example, you can configure the system to send only specific alerts to an alert recipient, configuring an
alert recipient to receive notifications only when Critical (severity) information about the System (alert
type) is sent.
example, you can configure the system to send only specific alerts to an alert recipient, configuring an
alert recipient to receive notifications only when Critical (severity) information about the System (alert
type) is sent.
Note
If you enabled AutoSupport during System Setup, the email address specified will receive alerts for all
severities and classes by default. You can change this configuration at any time.
severities and classes by default. You can change this configuration at any time.
Procedure
Step 1
Select System Administration > Alerts.
Step 2
Click Add Recipient.
Step 3
Enter the recipient’s email address. You can enter multiple addresses, separated by commas.
Date: 23 Mar 2005 21:10:19 +0000
To: joe@example.com
From: IronPort C60 Alert [alert@example.com]
Subject: Critical-example.com: (Anti-Virus) update via http://newproxy.example.com
failed
The Critical message is:
update via http://newproxy.example.com failed
Version: 4.5.0-419
Serial Number: XXXXXXXXXXXX-XXXXXXX
Timestamp: Tue May 10 09:39:24 2005
For more information about this error, please see
http://support.ironport.com
If you desire further information, please contact your support provider.