Cisco Cisco Email Security Appliance C170 Guia Do Utilizador

In this example portion of the 

systemsetup

 command, a private listener named OutboundMail is 

configured to run on the PrivateNet IP interface. Then, it is configured to relay all email for all hosts 
within the domain 

example.com

. (Note the dot at the beginning of the entry: 

.example.com

)

The default value for rate limiting (not enabled) and the default host access policy for this listener are 
then accepted.

Note that the default values for a private listener differ from the public listener created earlier. For more 
information, see 

.

Do you want to configure the C60 to relay mail for internal hosts?  [Y]> y

Please create a name for this listener (Ex: "OutboundMail"):

[]> OutboundMail

Please choose an IP interface for this Listener.

1. Management (192.168.42.42/24: mail3.example.com)

2. PrivateNet (192.168.1.1/24: mail3.example.com)

3. PublicNet (192.168.2.1/24: mail3.example.com)

[1]> 2

Please specify the systems allowed to relay email through the IronPort C60.

Hostnames such as "example.com" are allowed.

Partial hostnames such as ".example.com" are allowed.

IP addresses, IP address ranges, and partial IP addressed are allowed.

Separate multiple entries with commas.

[]> .example.com

Do you want to enable rate limiting for this listener? (Rate limiting defines the 

maximum number of recipients per hour you are willing to receive from a remote domain.)  

[N]> n

Default Policy Parameters

==========================