Cisco Cisco Email Security Appliance C170 Guia Do Utilizador

To connect via Ethernet: Start an SSH or Telnet session with the factory default IP address 
192.168.42.42. SSH is configured to use port 22. Telnet is configured to use port 23. Enter the username 
and password below. 

To connect via a Serial connection: Start a terminal session with the communication port on your 
personal computer that the serial cable is connected to. Use the settings for serial port outlined in 

. Enter the username and password below. 

Log in to the appliance by entering the username and password below.

Username: 

Password: 

For example: 

The CLI version of the System Setup Wizard basically mirrors the steps in the GUI version, with a few 
minor exceptions:

The CLI version includes prompts to enable the web interface.

The CLI version allows you to edit the default Mail Flow Policy for each listener you create. 

The CLI version contains prompts for configuring the global Anti-Virus and Outbreak Filters 
security settings.

The CLI version does not prompt you to create an LDAP profile after the system setup is complete. 
Use the 

ldapconfig

 command to create an LDAP profile.

To run the System Setup Wizard, type 

systemsetup

 at the command prompt.

The System Setup Wizard warns you that you will reconfigure your system. If this is the very first time 
you are installing the appliance, or if you want to completely overwrite your existing configuration, 
answer “Yes” to this question. 

login: admin

password: ironport

IronPort> systemsetup

WARNING: The system setup wizard will completely delete any existing

'listeners' and all associated settings including the 'Host Access Table' - mail 

operations may be interrupted.

Are you sure you wish to continue? [Y]> Y