Cisco Cisco Email Security Appliance C170 Guia Do Utilizador

Página de 630
5-109
Cisco IronPort AsyncOS 7.1 for Email Configuration Guide
OL-22158-02
Chapter 5      Configuring the Gateway to Receive Email
Note
When you create a new listener via the System Setup Wizard, AsyncOS creates 
the listener with default values. However, when you create a listener manually, 
AsyncOS does not use these default SBRS values.
Use the Listeners page (Network > Listeners) or the 
listenerconfig
 command 
to configure listeners that run over available IP interfaces on the IronPort 
appliance. For more information about creating and configuring listeners, see the 
“Customizing Listeners” chapter in the Cisco IronPort AsyncOS for Email 
Advanced Configuration Guide
. In “Using Virtual Gateway™ Technology” in the 
Cisco IronPort AsyncOS for Email Advanced Configuration Guide, the IronPort 
Virtual Gateway technology is explained, in which you can further define and 
group IP interfaces over one or many IP addresses, or groups of IP addresses.
Figure 5-1
Relationship Between Listeners, IP Interfaces, and Physical 
Ethernet Interfaces
Enterprise Gateway Configuration
In this configuration, the Enterprise Gateway configuration accepts email from 
the Internet and relays email to groupware servers, POP/IMAP servers, or other 
MTAs. At the same time, the enterprise gateway accepts SMTP messages from 
groupware servers and other email servers for relay to recipients on the Internet. 
Physical Ethernet interface
IP interface
Listener 
Port
IP address
Physical interface 
IronPort Email 
Security appliance