Cisco Cisco Email Security Appliance C170 Guia Do Utilizador

After you successfully configure your appliance to work with your Active 
Directory Wizard, or skip the process, the System Setup Next Steps page appears.

Click the links on the System Setup Next Steps page to proceed with the 
configuration of your IronPort appliances. 

Access to the CLI varies depending on the management connection method you 
chose in 

. The factory default username 

and password are listed next. Initially, only the admin user account has access to 
the CLI. You can add other users with differing levels of permission after you have 
accessed the command line interface for the first time via the admin account. (For 
information about adding users, see “Common Administrative Tasks” in the Cisco 
IronPort AsyncOS for Email Daily Management Guide.) The System Setup 
Wizard asks you to change the password for the admin account. The password for 
the admin account can also be reset directly at any time using the password 
command. 

To connect via Ethernet: Start an SSH or Telnet session with the factory default 
IP address 192.168.42.42. SSH is configured to use port 22. Telnet is configured 
to use port 23. Enter the username and password below. 

To connect via a Serial connection: Start a terminal session with the 
communication port on your personal computer that the serial cable is connected 
to. Use the settings for serial port outlined in 

. Enter the username and password below.