Cisco Cisco Email Security Appliance C170 Guia Do Utilizador

If you enabled AutoSupport during System Setup, the email address specified will receive alerts for all 
severities and classes by default. You can change this configuration at any time.

Select System Administration > Alerts.

Click Add Recipient. 

Enter the recipient’s email address. You can enter multiple addresses, separated by commas.

(Optional) If you want to receive software release and critical support notification alerts from Cisco 
Support, check the Release and Support Notifications checkbox. 

Select the alert types and severities that this recipient will receive.

Submit and commit your changes.

The following settings apply to all alerts.

Use the 

alertconfig

 CLI command to define the number of alerts to save on the appliance to view later.

Click Edit Settings on the Alerts page. 

Enter a Header From: address to use when sending alerts, or select Automatically Generated 
(“alert@<hostname>”).

Mark the checkbox if you want to specify the number of seconds to wait between sending duplicate 
alerts. For more information, see 

Specify the initial number of seconds to wait before sending a duplicate alert.

Specify the maximum number of seconds to wait before sending a duplicate alert.

You can enable AutoSupport by checking the IronPort AutoSupport option. For more information about 
AutoSupport, see 

.

If AutoSupport is enabled, the weekly AutoSupport report is sent to alert recipients set to receive 
System alerts at the Information level. You can disable this via the checkbox.

Submit and commit your changes.

Alert settings control the general behavior and configuration of alerts, including: