Cisco Cisco Aironet 340 Ethernet Bridges Guia Do Utilizador

are defaults. You may determine into which configuration group each 
setting resides with the use of the configuration dump described in 
Chapter 3

Network connection commands are performed using the Network Menu. 
To access this menu, select Diagnostics from the Main Menu the select 
Network.

The connect option is used to start a telnet session with a remote unit on 
the infrastructure to gain access to its Console Menu. The connect 
option can also be used to access any remote node (PC or Server) that 
supports telnet access. 

The connection may be initiated using the remote node’s IP address. The 
connection is completely routable and the destination may be anywhere 
in the internet.

If the connection is to be made to another Aironet unit which has not 
been assigned an IP address, start the connection using the MAC level 
infrastructure address of the unit. This connection uses a proprietary 
protocol which is not routable. The destination must lie on the local 
LAN. This is useful when assigning IP addresses to a large number of 
bridges.

                 Diagnostics Network Menu

    Option         Value        Description

1 - Connect                   - Start telnet session

2 - Escape     [ “^X^Y^Z” ]   - Connection escape sequence

3 - Find                      - Flash LEDs to find unit

4 - Ping                      - Send an IP PING packet

Enter an option number or name, “=” main menu, <ESC> previous menu

>_