Cisco Cisco Aironet 340 Ethernet Bridges Guia Do Utilizador
Configuring the Radio Network 4 - 15
Viewing Errors (Errors)
The errors option is used to view the Radio Error statistics that may
have occurred during the link test. See Chapter 9 “Viewing Statistics”.
have occurred during the link test. See Chapter 9 “Viewing Statistics”.
Continuously Running a Link Test (Continuous)
The continuous option is used to continuously repeat the link tests. If
the value for the parameter is zero the tests are not repeated; otherwise,
the value determines the delay (in seconds) between tests.
the value for the parameter is zero the tests are not repeated; otherwise,
the value determines the delay (in seconds) between tests.
Setting the Automatic Link Test Mode (Autotest)
The autotest option is used to control the automatic running of a link
test whenever a repeater associates to its parent. The test will use the
currently configured test parameters which, by default, runs a test to the
parent node.
test whenever a repeater associates to its parent. The test will use the
currently configured test parameters which, by default, runs a test to the
parent node.
n Off: An automatic test is never run.
n Once: Only one test is run the first time the unit associates to a par-
ent after powering on.
n Always: The test is run each time the unit associates to a parent.