Cisco Cisco Packet Data Gateway (PDG) Guia Da Instalação
Initial System Configuration
MIO/UMIO Port Numbering ▀
ASR 5500 Installation Guide ▄
119
MIO/UMIO Port Numbering
The two 1 GbE ports on the MIO/UMIO cards in slots 5 and 6 can only be used as management ports. 10 GbE ports can
only be used for non-local contexts (service ports). MIO/UMIO port numbers are non-contiguous.
only be used for non-local contexts (service ports). MIO/UMIO port numbers are non-contiguous.
Important:
For lab environments where network booting of the chassis is desirable, Ethernet 1 port on an
MIO/UMIO can be used to network boot the chassis. Other MIO/UMIO ports cannot be used for network booting.
The MIO/UMIO is equipped with two daughter cards (DCs). Each DC supports ten 10 GbE ports.
Ports are specified in CLI commands by “x/yy” where x is the slot number (5 or 6) and yy the port number (1 to 29). For
example, show port info 5/20 [slot 5, port 20].
example, show port info 5/20 [slot 5, port 20].
Table 20. MIO/UMIO Port Numbering
Port Number
Type
Connector
MIO DC
Notes
1
1000Base-T
RJ45
—
Management Port
2
1000Base-T
RJ45
—
Management Port
3
RS-232
RJ45
—
Console (serial)
4 – 9
—
—
—
Unassigned
10 – 19
10GbE
SFP+
Top
Service Port
20 – 29
10GbE
SFP+
Bottom
Service Port
The output of the show port table command reflects the port numbering scheme in the table above for MIO/UMIO
cards equipped with two 10-port, 10 GbE daughter cards.
cards equipped with two 10-port, 10 GbE daughter cards.