Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Context Configuration Mode Commands
▀ hnbgw-service
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
hnbgw-service
This command creates/removes an Home NodeB Gateway (HNB-GW) service or configures an existing HNB-GW
service and enters the HNB-GW service configuration mode for Femto UMTS access networks in the current context.
service and enters the HNB-GW service configuration mode for Femto UMTS access networks in the current context.
Product
HNB-GW
Privilege
Administrator
Syntax
Removes the specified HNB-GW service from the context.
Specifies the name of the HNB-GW service. If
does not refer to an existing service, the
new service is created if resources allow.
must be from 1 to 63 alpha and/or numeric characters.
Indicates that the command is to execute without any additional prompt and confirmation from the user.
Usage
Use this command to enter the HNB-GW service configuration mode for an existing service or for a newly
defined service. This command is also used to remove an existing service.
A maximum of 8 HNB-GW service can be configured on a system which is further limited to a maximum of
256 services (regardless of type) can be configured per system.
defined service. This command is also used to remove an existing service.
A maximum of 8 HNB-GW service can be configured on a system which is further limited to a maximum of
256 services (regardless of type) can be configured per system.
Caution:
Large numbers of services greatly increase the complexity of management and may impact overall
system performance (for example, resulting from such things as system handoffs). Therefore, it is recommended that a
large number of services only be configured if your application absolutely requires it. Please contact your local service
representative for more information.
large number of services only be configured if your application absolutely requires it. Please contact your local service
representative for more information.
Entering this command results in the following prompt:
The commands configured in this mode are defined in the HNB-GW Service Configuration Mode Commands
chapter of Command Line Interface Reference.
chapter of Command Line Interface Reference.
Caution:
This is a critical configuration. The HNB-GW service can not be configured without this
configuration. Any change to this configuration would lead to restarting the HNB-GW service and removing or
disabling this configuration will stop the HNB-GW service.
disabling this configuration will stop the HNB-GW service.