Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Ethernet Interface Configuration Mode Commands
▀ ip ospf intervals
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
ip ospf intervals
This command configures the interval or delay type, and the interval or delay time in seconds, for OSPF
communications.
communications.
Product
PDSN, HA, GGSN
Privilege
Security Administrator, Administrator
Syntax
Deletes the value set and returns the value to its default.
Default: 40
The interval, in seconds, that the router should wait, during which time no packets are received and after the
router considers a neighboring router to be off-line.
The interval, in seconds, that the router should wait, during which time no packets are received and after the
router considers a neighboring router to be off-line.
must be an integer from 1 through 65535.
Default: 10
The interval, in seconds between sending hello packets.
The interval, in seconds between sending hello packets.
must be an integer from 1 through 65535.
Default: 5
The interval, in seconds, between LSA (Link State Advertisement) retransmissions.
The interval, in seconds, between LSA (Link State Advertisement) retransmissions.
must be an
integer from 1 through 65535.
Default: 1
The interval, in seconds, that the router should wait before transmitting a packet.
The interval, in seconds, that the router should wait before transmitting a packet.
must be an integer
from 1 through 65535.
Usage
Use this command to set the intervals or delays for OSPF communications.
Example
To set the dead-interval to 100, use the following command;
To set the dead-interval to 100, use the following command;