Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
IPv6 ACL Configuration Mode Commands
deny/permit (any) ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
deny/permit (any)
Used to filter subscriber sessions based on any packet received. This command is also used to set the access control list
insertion point.
insertion point.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Indicates all rules defined subsequent to this command are to be inserted after the command identified by the
exact options listed.
This moves the insertion point to be immediately after the rule which matches the exact options specified
such that new rules will be added, in order, after the matching rule.
exact options listed.
This moves the insertion point to be immediately after the rule which matches the exact options specified
such that new rules will be added, in order, after the matching rule.
Important:
If the options specified do not exactly match an existing rule, the insertion point does not change.
Indicates all rules defined subsequent to this command are to be inserted before the command identified by
the exact options listed.
This moves the insertion point to be immediately before the rule which matches the exact options specified
such that new rules will be added, in order, before the matching rule.
the exact options listed.
This moves the insertion point to be immediately before the rule which matches the exact options specified
such that new rules will be added, in order, before the matching rule.
Important:
If the options specified do not exactly match an existing rule, the insertion point does not change.
Removes the rule which exactly matches the options specified.
Specifies the rule is either block (deny) or an allow (permit) filter.
: indicates the rule, when matched, drops the corresponding packets.
: indicates the rule, when matched, allows the corresponding packets.
Default: packets are not logged.