Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
MAG Service Configuration Mode Commands
▀ bind address
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
bind address
Binds the service to a logical IP interface serving as the S2a (HSGW) or S5/S8 (S-GW) interface and specifies the
maximum number of subscribers that can access this service over the configured interface.
maximum number of subscribers that can access this service over the configured interface.
Product
HSGW, S-GW
Privilege
Administrator
Syntax
Removes the interface binding from this service.
Specifies the IPv6 address of the interface configured as the S5/S8 interface.
is specified in
colon separated notation.
Default: 1500000
Specifies the maximum number of subscribers that can access this service on this interface.
Specifies the maximum number of subscribers that can access this service on this interface.
must be
configured to an integer between 0 and 3000000.
Important:
The maximum number of subscribers supported is dependant on the license key installed and the
number of active PSCs in the system. A fully loaded system with 13 active PSCs can support 3,000,000 total
subscribers. Refer to the license key command and the Usage section (below) for additional information.
subscribers. Refer to the license key command and the Usage section (below) for additional information.
Usage
Associate the MAG service to a specific logical IP address. The logical IP address or interface takes on the
characteristics of an S2a or S5/S8 interface that provides the session connectivity to/from a PDN gateway.
Only one interface can be bound to a service. The interface should be configured prior to issuing this
command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
characteristics of an S2a or S5/S8 interface that provides the session connectivity to/from a PDN gateway.
Only one interface can be bound to a service. The interface should be configured prior to issuing this
command.
This command also sets a limit as to the number of simultaneous subscribers sessions that can be facilitated
by the service/interface at any given time.
When configuring the
option, be sure to consider the following:
The total number of S2a or S5/S8 interfaces you will configure
The total number of subscriber sessions that all of the configured interfaces may handle during peak
busy hours
An average bandwidth per session multiplied by the total number of sessions
The type of physical port (10/100Base-T or 1000Base-Tx) that these interfaces will be bound to