Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
MME Service Configuration Mode Commands
bind s1-mme ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
bind s1-mme
This command binds the MME service to a logical IP interface serving as the S1-MME interface.
Product
MME
Privilege
Security Administrator, Administrator
Syntax
Removes a previously configured IP address use for binding the SCTP (local bind address) to communicate
with the eNodeBs using S1-MME interface.
with the eNodeBs using S1-MME interface.
Specifies the IP address (address) in IPv4 or IPv6 notation for the interface configured as an S1-MME
interface.
interface.
Usage
Use this command to associate or tie the MME service to a specific logical IP address that will be used for
binding the SCTP socket to communicate with the eNodeB using S1AP. A maximum of one IP address can
be configured with this command for one MME service.
The MME passes the IP address during setting up the SCTP association with the eNodeB.
binding the SCTP socket to communicate with the eNodeB using S1AP. A maximum of one IP address can
be configured with this command for one MME service.
The MME passes the IP address during setting up the SCTP association with the eNodeB.
Caution:
This is a critical configuration. The MME service can not be started without this configuration. Any
change to this configuration would lead to restarting the MME service and removing or disabling this configuration will
stop the MME service.
stop the MME service.
Example
The following command would bind the logical IP interface with the address of
The following command would bind the logical IP interface with the address of
to the MME service to
interact with eNodeB.
The following command disables a binding that was previously configured: