Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
MME Service Configuration Mode Commands
emm ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
Sets the timeout duration for T3413 timer. The timer starts when MME initiates the EPS paging procedure to
the EMM entity in the network and requests the lower layer to start paging. This timer stops for the paging
procedure when a response received from the UE.
the EMM entity in the network and requests the lower layer to start paging. This timer stops for the paging
procedure when a response received from the UE.
is timeout duration in seconds and must be an integer from 1 through 20.
Default: 10
Sets the timeout duration for T3422 timer. This timer starts when MME initiates the detach procedure by
sending a DETACH REQUEST message to the UE and stops upon receipt of the DETACH ACCEPT
message.
Sets the timeout duration for T3422 timer. This timer starts when MME initiates the detach procedure by
sending a DETACH REQUEST message to the UE and stops upon receipt of the DETACH ACCEPT
message.
is timeout duration in seconds and must be an integer from 1 through 20.
Default: 5400
Sets the timeout duration for T3423 timer. This timer starts when UE enters the EMM-DEREGISTERED
state or when entering EMM-CONNECTED mode. It stops while the UE is in EMM-REGISTERED.NO-
CELL-AVAILABLE state and Idle mode Signalling Reduction (ISR) is activated.
Sets the timeout duration for T3423 timer. This timer starts when UE enters the EMM-DEREGISTERED
state or when entering EMM-CONNECTED mode. It stops while the UE is in EMM-REGISTERED.NO-
CELL-AVAILABLE state and Idle mode Signalling Reduction (ISR) is activated.
is timeout duration in seconds and must be an integer from 1 through 11160.
Default: 6
Sets the timeout duration for T3450 timer. This timer starts when MME initiates the Globally Unique
Temporary Identifier (GUTI) reallocation procedure by sending a GUTI REALLOCATION COMMAND
message to the UE and stops upon receipt of the GUTI REALLOCATION COMPLETE message.
This timer is also used for Tracking area update procedure.
Sets the timeout duration for T3450 timer. This timer starts when MME initiates the Globally Unique
Temporary Identifier (GUTI) reallocation procedure by sending a GUTI REALLOCATION COMMAND
message to the UE and stops upon receipt of the GUTI REALLOCATION COMPLETE message.
This timer is also used for Tracking area update procedure.
is timeout duration in seconds and must be an integer from 1 through 20.
Default: 6
Sets the timeout duration for T3460 timer. The timers starts when the network initiates the authentication
procedure by sending an AUTHENTICATION REQUEST message to the UE and stops upon receipt of the
AUTHENTICATION RESPONSE message.
Sets the timeout duration for T3460 timer. The timers starts when the network initiates the authentication
procedure by sending an AUTHENTICATION REQUEST message to the UE and stops upon receipt of the
AUTHENTICATION RESPONSE message.
is timeout duration in seconds and must be an integer from 1 through 20.
Default: 6
Sets the timeout duration for T3470 timer. The MME starts this timer when the network initiates the
identification procedure by sending an IDENTITY REQUEST message to the UE and stops upon receipt of
the IDENTITY RESPONSE message.
Sets the timeout duration for T3470 timer. The MME starts this timer when the network initiates the
identification procedure by sending an IDENTITY REQUEST message to the UE and stops upon receipt of
the IDENTITY RESPONSE message.
is timeout duration in seconds and must be an integer from 1 through 20.
Usage
Use this command to set EMM timers.
Following tables describe the triggers and states for timers:
Following tables describe the triggers and states for timers: