Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
OSPF Configuration Mode Commands
▀ area virtual link intervals
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
area virtual link intervals
This command configures the interval or delay type, and the delay time in seconds, for the virtual link between an area
that cannot be physically connected to the network backbone and an area that is physically connected to the network
backbone.
that cannot be physically connected to the network backbone and an area that is physically connected to the network
backbone.
Product
PDSN, HA, GGSN
Privilege
Security Administrator, Administrator
Syntax
{
|
}
[
] [
] [
] [
]
The IP address, in IPv4 dotted-decimal notation, of the area.
The identification number of the transit area. This must be an integer from 0 through 4294967295.
The router id, in dotted-decimal notation, of the ABR to be linked to.
The interval, in seconds, that the router should wait, during which time no packets are received and after the
router considers a neighboring router to be off-line.
router considers a neighboring router to be off-line.
must be an integer from 1 through 65535.
The interval, in seconds before sending a hello packet.
must be an integer from 1 through 65535.
The interval, in seconds, that router should wait before retransmitting a packet.
must be an integer
from 1 through 65535.
The interval, in seconds, that the router should wait before transmitting a packet.
must be an integer
from 1 through 65535.
Usage
Use this command to set the intervals or delay types for a virtual link between an area that is connected to the
network backbone and an area that cannot be connected to the network backbone.
network backbone and an area that cannot be connected to the network backbone.