Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas

Página de 5302
Rulebase Configuration Mode Commands   
▀  cca quota 
 
▄  Cisco ASR 5000 Series Command Line Interface Reference 
OL-22948-01   
cca quota 
This command is used to set various time and threshold-based quotas in the prepaid credit control service. 
Product
 
All 
Privilege
 
Security Administrator, Administrator 
Syntax
 
Specifies the value for the Quota Holding Time (QHT). QHT is used with both time-based and volume-based 
quotas. 
 must be an integer from 1 to 4000000000. 
After 
 seconds has passed without user traffic, the quota is reported back and the charging 
stops until new traffic starts. 
Specifies the content ID (Rating group AVP) to use for the Quota holding time for this rulebase. 
 is the specified content id for credit control service in an active charging service and must be an 
integer from 0 through 4,294,967,295. 
Default: 60 
Specifies the retry time in seconds for the quota request. 
 must be an integer from 0 to 86400. To disable this assign 0. 
This defines the maximum frequency at which the CC application tries to obtain quota for a subscriber 
passing traffic for a category with no/exhausted quota. 
For a subscriber not passing traffic, the CC application will not try to obtain quota (except once at session 
start time, if so configured). i.e. the quota request from the no quota state is sent in response to user packets 
only, never based on a timer. 
When subscriber hits a charging action that is a flow redirect, operator can optionally specify that this 
redirection shall clear the retry-time timer. 
This allows the immediately following chargeable user traffic to trip a quota request, even if it would 
otherwise have been subject to the retry time limit. Such configuration allows quite large value for retry-time 
in quota charging or top up scenario. 
 
 option configures the maximum number of retries allowed for blacklisted 
categories. This option has default value of maximum retries of 65535 retries. 
 must be an integer from 1 through 65535. To disable this assign 0. 
Usage
 
Use this command to set the prepaid credit control quotas. 
 allows operator to set the amount of time that the ACS waits before it retries 
the prepaid server for a content id for which quota was exausted earlier.