Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas

Página de 5302
Subscriber Configuration Mode Commands   
▀  ip allowed-dscp 
 
▄  Cisco ASR 5000 Series Command Line Interface Reference 
OL-22948-01   
ip allowed-dscp 
This command sets the Quality of Service (QoS) Differentiated Services (DiffServ) marking that a subscriber session is 
allowed. This is disabled by default. 
Product
 
All 
Privilege
 
Security Administrator, Administrator 
Syntax
 
 
 
 
 
 
 [ 
 
 ] 
 
 
 
 
Resets the parameters to the defaults: class none, max-class 
. This indicates that all packets are let through 
without any dscp checking 
This parameter specifies the Differentiated Services Codepoint (DSCP) class that the subscriber session may 
mark its packets with. If the subscriber sessions packets request a code point class higher than the code point 
class specified, the PDSN service re-marks the packets with the QOS-DSCP value specified by the 
 command. 
Default: none 
 must be one of the following; 
: packets with AF DSCPs are allowed 
: packets with EF DSCP are allowed 
: packets for experimental or local use are allowed 
: packets with AF and EF DSCPs are allowed 
: packets with AF DSCPs or packets for experimental or local use are allowed 
: packets with EF DSCPs or packets for experimental or local use are allowed 
: packets with AF or EF DSCPs or packets for experimental or local use are allowed 
: only the 
 and 
 through 
 code points are allowed 
This parameter specifies the maximum code point that a subscriber session may mark its packets with. The 
subscriber sessions packets must be marked with a code point equal to or less than the code point specified. If 
the subscriber sessions packets request a code point higher than the code point specified, the PDSN service 
re-marks the packets with the QOS-DSCP value specified by the lower of the max-class and the 
 command. 
The list below lists the code points from lowest to highest precedence. For example, if the 
 is set 
to af22, that becomes the maximum code point that the subscriber session may mark it‘s packets with and 
only 
, and 
 are allowed. If a subscriber session marks its packets 
with anything after af22 in this list, the PDSN service re-marks the packets with the QOS-DSCP value 
specified by the lower of the maxclass and the 
 command. 
If class is set to none only the be and sc1 through sc7 codepoints are allowed. For example; if 
 is set to 
none and you set 
 to 
, only the 
 and 
 codepoints are allowed. 
Default: 
 
 must be one of the following;