Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
ASN Gateway Service Configuration Mode Commands
▀ handover
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
handover
This command specifies the handover-related parameters between BS, ASN GW, and MS.
Product
ASN GW
Privilege
Administrator
Syntax
Sets the default values for configured handover parameters.
Configures datapath pre-registration and/or termination parameters for an anchor gateway handover.
Default: 5
Configures the maximum duration in seconds that a single MS can keep the pre-registration datapath with the
previous BS after a completed handover to another BS.
Configures the maximum duration in seconds that a single MS can keep the pre-registration datapath with the
previous BS after a completed handover to another BS.
is measured in seconds. Configure as any integer from 0 through 65535.
Default: 0
Configures the maximum duration in seconds for which the datapath with the previous BS is maintained after
a completed handover to another BS. The system maintains the old datapath for the specified period after the
new datapath setup is completed, and then terminates it.
Configures the maximum duration in seconds for which the datapath with the previous BS is maintained after
a completed handover to another BS. The system maintains the old datapath for the specified period after the
new datapath setup is completed, and then terminates it.
is measured in seconds. Configured as any integer from 0 through 65535.
Default: 1
Configures the maximum number of pre-registrations from multiple BSs that a single MS can keep at a time.
Configures the maximum number of pre-registrations from multiple BSs that a single MS can keep at a time.
is the number of pre-registrations. Configure as any integer from 0 through 5.
Configures datapath pre-registration and/or termination parameters for a non-anchor gateway handover.