Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
BMSC Profile Configuration Mode Commands
▀ gmb user-data
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
gmb user-data
This command configures the parameters in this BM-SC profile for user data of MBMS user service.
Product
GGSN
Privilege
Security Administrator, Administrator
Syntax
Removes the configured self address of GGSN for unicast in BM-SC profile for user data of MBMS user
service.
service.
Sets the user data mode to unicast in BM-SC profile for user data of MBMS user service.
Default: unicast
Specifies the preferred mode of GGSN for receiving MBMS suer service data.
multicast: specifies the preferred mode as multicast for MBMS user service.
Specifies the preferred mode of GGSN for receiving MBMS suer service data.
multicast: specifies the preferred mode as multicast for MBMS user service.
Important:
Note that this multicast keyword is not supported in this release.
unicast: specifies the preferred mode as unicast for MBMS user service.
Specifies the GGSN‘s IP address for BM-SC to use as outer destination address for the IP-in-IP tunnel to
send multicast data if configured preferred data mode is unicast.
send multicast data if configured preferred data mode is unicast.
must be the IPv4 address in dotted decimal notation.
This command must be configured if GGSN's user-data mode-preference is Unicast.
Usage
Use this command to configure user data mode and other parameters in BM-SC profile for user data of
MBMS user service.
GGSN can receive multicast data from BM-SC in one of two modes - Multicast or Unicast. In Unicast mode,
BM-SC tunnels the multicast data to the GGSN in an IP-in-IP tunnel instead of direct multicast. This
MBMS user service.
GGSN can receive multicast data from BM-SC in one of two modes - Multicast or Unicast. In Unicast mode,
BM-SC tunnels the multicast data to the GGSN in an IP-in-IP tunnel instead of direct multicast. This