Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Border Gateway Protocol Address-Family Configuration Mode Commands
neighbor ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
use this keyword to bind the specified IP address to the bgp socket that is used to communicate to the peer.
is an IPv4 address in dotted decimal notation.
In most cases you should set the update-source address to the address of the loopback interface in the current
context. By doing this, the tcp connection does not go down until there is no route for the loopback address in
the peering router.
context. By doing this, the tcp connection does not go down until there is no route for the loopback address in
the peering router.
This command sets the default weight for routes from this neighbor.
Default: 0
Default: 0
: This must be an integer from 0 through 65535.
Usage
Use this command to set parameters for communication with a specified neighbor. The chassis supports a
maximum of 64 peers per context.
maximum of 64 peers per context.
Example
The following command specifies that the neighbor at the IP address 192.168.100.25 has an AS number of 2000:
The following command specifies that the neighbor at the IP address 192.168.100.25 has an AS number of 2000:
The following command allows BGP neighbors that are a maximum of 27 hops away:
The following command sets the minimum interval between sending routing updates to 3 minutes
The following command sets the default weight for all routes from the specified neighbor to 100: