Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Context Configuration Mode Commands
▀ nw-reachability server
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
nw-reachability server
This command adds/deletes a reachability-detect server and configures parameters for retrying the failure-detection
process. When network reachability is enabled, a ping request is sent to this device. If there is no response after a
specified number of retries, the network is deemed failed. Execute this command multiple times to configure multiple
network reachability servers.
process. When network reachability is enabled, a ping request is sent to this device. If there is no response after a
specified number of retries, the network is deemed failed. Execute this command multiple times to configure multiple
network reachability servers.
Product
HA
Privilege
Security Administrator, Administrator
Syntax
Delete the reference to the specified network reachability server.
A name for the network device that is sent ping packets to test for network reachability.
Default: 60 seconds
Specifies the frequency in seconds for sending ping requests.
Specifies the frequency in seconds for sending ping requests.
must be an integer from 1 through
3600.
Specifies the IP address to be used as the source address of the ping packets; If this is unspecified, an
arbitrary IP address that is configured in the context is used.
arbitrary IP address that is configured in the context is used.
must be an IP v4 address in dotted
decimal notation.
Default: 5
Specifies the number of retries before deciding that there is a network-failure.
Specifies the number of retries before deciding that there is a network-failure.
must be an integer from 0
through 100.
Specifies the IP address of a network element to use as the destination to send the ping packets for detecting
network failure or reachability.
network failure or reachability.
must be an IP v4 address in dotted decimal notation.
Default: 3 seconds