Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Global Configuration Mode Commands
threshold per-service-gprs-sessions ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
threshold per-service-gprs-sessions
Configures the thresholds for the number of 2G-attached subscribers per GPRS service.
Product
SGSN
Privilege
Security Administrator, Administrator
Syntax
Default: 0
The high threshold number of 2G-attached subscribers for any one GPRS service. This threshold number
must be met or exceeded within the polling interval to generate an alert or alarm.
The number can be configured to any integer value from 0 through 2000000. A value of 0 disables the
threshold.
The high threshold number of 2G-attached subscribers for any one GPRS service. This threshold number
must be met or exceeded within the polling interval to generate an alert or alarm.
The number can be configured to any integer value from 0 through 2000000. A value of 0 disables the
threshold.
Default: 0
The low threshold number of 2G-attached subscribers for any one GPRS service. The number of subscribers
must remain above this threshold in order to maintain a previously generated alarm condition. If the number
of 2G subscribers falls beneath the low threshold within the polling interval, then a clear alarm will be
generated.
The number can be configured to any integer value between 0 and 2000000. A value of 0 disables the
threshold.
The low threshold number of 2G-attached subscribers for any one GPRS service. The number of subscribers
must remain above this threshold in order to maintain a previously generated alarm condition. If the number
of 2G subscribers falls beneath the low threshold within the polling interval, then a clear alarm will be
generated.
The number can be configured to any integer value between 0 and 2000000. A value of 0 disables the
threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Monitor and set alarms or alerts when the number of 2G-attached subscribers for any GPRS service in the
system is equal to or greater than the set limit.
Alerts or alarms are triggered for PDP contexts based on the following rules:
system is equal to or greater than the set limit.
Alerts or alarms are triggered for PDP contexts based on the following rules:
Enter condition: Actual number of 2G-attached subscribers for any GPRS service ³ High Threshold
Clear condition: Actual number of 2G-attached subscribers < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command to configure the polling interval and the
command to enable thresholding for this value.
Example