Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
OSPF Configuration Mode Commands
▀ neighbor
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
neighbor
This command configures OSPF routers that interconnect to non-broadcast networks.
Product
PDSN, HA, GGSN
Privilege
Security Administrator, Administrator
Syntax
[
] [
]
The interface IP address of the OSPF neighbor. This must be an IP address entered in dotted-decimal
notation.
notation.
Default: 120
Set the number of seconds in the dead neighbor polling interval. This must be an integer from 1 through
65535
Set the number of seconds in the dead neighbor polling interval. This must be an integer from 1 through
65535
Default: 0
Set the 8-bit number that represents the router priority value of the non-broadcast neighbor associated with
the IP address specified. This must be an integer from 0 through 255. This keyword does not apply to point-
to-multipoint interfaces.
Set the 8-bit number that represents the router priority value of the non-broadcast neighbor associated with
the IP address specified. This must be an integer from 0 through 255. This keyword does not apply to point-
to-multipoint interfaces.
Usage
Use this command to configure OSPF routers that connect to non-broadcast networks.
Example
The following command specifies an OSPF router neighbor with the IP address of
The following command specifies an OSPF router neighbor with the IP address of
:
neighbor