Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
SGSN Operator Policy Configuration Mode Commands
▀ direct-tunnel
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
direct-tunnel
This command allows direct tunneling if the direct tunneling is supported by destination node.
Product
SGSN
Privilege
Security Administrator, Administrator
Syntax
Removes the configured setting to permit direct tunneling in this operator policy.
Default: Disabled.
Enables direct tunneling if the destination node allows it.
Enables direct tunneling if the destination node allows it.
Usage
Use this command to enable the direct-tunnel feature at the operator policy level.
To ensure that direct tunnel is supported, check the settings of the
To ensure that direct tunnel is supported, check the settings of the
commands in the
SGSN APN policy configuration mode and the Radio Network Controller (release 8.0) or RNC (releases 8.1
or higher) configuration mode. Direct tunneling must be enabled at these two point to allow direct tunneling
for the MS/UE.
or higher) configuration mode. Direct tunneling must be enabled at these two point to allow direct tunneling
for the MS/UE.
Example
The following command sets the SGSN operator policy to attempt to setup a direct tunnel if permitted at the destination
node:
The following command sets the SGSN operator policy to attempt to setup a direct tunnel if permitted at the destination
node: