Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Subscriber Configuration Mode Commands
pdif mobile-ip ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
pdif mobile-ip
Configures PDIF subscriber call setup parameters.
Product
PDIF
Privilege
Security Administrator, Administrator
Syntax
Disables the option specified.
Specifies that after subscriber call setup is complete, the tunnel inner address (TIA) is released. If SImple IP
is enabled, the TIA becomes the principal communications tunnel and the restriction that it is only to be used
to set up a Mobile-IP call is lifted. This parameter is disabled by default.
is enabled, the TIA becomes the principal communications tunnel and the restriction that it is only to be used
to set up a Mobile-IP call is lifted. This parameter is disabled by default.
Specifies that Mobile IP is required for this subscriber whenever a call is set up. This parameter is disabled by
default.
default.
Specifies that Simple IP should be used when Mobile IP could not be established. This parameter is disabled
by default.
by default.
Usage
Use this command to configure specific behavior for the PDIF subscriber during call setup.
Example
The following command enables the system to fall back to Simple IP when Mobile IP fails for this subscriber during
call setup:
The following command enables the system to fall back to Simple IP when Mobile IP fails for this subscriber during
call setup: