Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
ACS Ruledef Configuration Mode Commands
▀ rule-application
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
rule-application
This command specifies the application rule for the rule definition.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Removes the previous rule application configuration.
Specifies that this rule definition only be used for routing purposes.
Up to 256 rule definitions can be defined for routing in an Active Charging Service.
Default: Disabled
Up to 256 rule definitions can be defined for routing in an Active Charging Service.
Default: Disabled
Important:
The
keyword is only available in StarOS 8.3 and later releases.
Specifies that this rule definition only be used for post-processing purposes. This enables processing of
packets even if the rule matching for them has been disabled.
packets even if the rule matching for them has been disabled.
Specifies that this rule definition only be used for charging purposes.
Up to 2048 rule definitions can be defined for charging application in an Active Charging Service.
Default: Enabled
Up to 2048 rule definitions can be defined for charging application in an Active Charging Service.
Default: Enabled
Usage
Use this command to assign a rule application to a rule definition.
If, when configuring a ruledef, the rule-application is not specified, by default the system configures the
ruledef as a charging ruledef.
If, when configuring a ruledef, the rule-application is not specified, by default the system configures the
ruledef as a charging ruledef.
Example
The following command assigns a rule application of
The following command assigns a rule application of
to the current rule definition: