Cisco Cisco Packet Data Gateway (PDG) Manual De Manutenção
AAA Interface Configuration
▀ Configuring Diameter AAA Functionality
▄ Cisco ASR 5000 Series AAA Interface Administration and Reference
OL-22955-01
Optional. To configure how long the system must wait for a response from a Diameter server before re-
transmitting the authentication request, in the Context Configuration Mode, use the following command:
Optional. To configure how many times a Diameter accounting request must be retried with the same server, if
the server fails to respond to a request, in the Context Configuration Mode, use the following command:
Optional. To configure the maximum number of transmission attempts for a Diameter accounting request, in the
Context Configuration Mode, use the following command. You can use this in conjunction with the
option to control how many servers will be attempted to communicate with.
Optional. To configure how long the system will wait for a response from a Diameter server before re-
transmitting the accounting request, in the Context Configuration Mode, use the following command:
Verifying Your Configuration
To verify your configurations:
In the Exec mode, enter the following command:
The output displays a concise list of settings that you have configured for the context.
Configuring Diameter Authentication Failure Handling
This section describes how to configure Diameter Authentication Failure Handling at the context level and the AAA
group level.
group level.
Configuring at Context Level
This section describes how to configure context-level error handling for EAP requests / EAP termination requests.
Specific actions (continue, retry-and-terminate, or terminate) can be associated with each possible result-code. Ranges
of result codes can be defined with the same action, or actions can be specific on a per-result code basis.
Specific actions (continue, retry-and-terminate, or terminate) can be associated with each possible result-code. Ranges
of result codes can be defined with the same action, or actions can be specific on a per-result code basis.
To configure Diameter Authentication Failure Handling at the context level use the following configuration: