Cisco Cisco Packet Data Gateway (PDG) Manual De Manutenção
Performance Management
Generally Available 06-30-2010
5-32
CLI (Global Configuration Mode)
[ default ] threshold poll { 10sec-cpu-utilization | a11-rrp-failure |
a11-rrq-msg-discard | a11-rac-msg-discard | aaa-acct-archive-size |
aaa-acct-failure | aaa-acct-failure-rate | aaa-auth-failure |
aaa-auth-failure-rate | aaa-retry-rate | aaamgr-request-queue |
active-subscriber | all-ppp-send-discard | available-ip-pool-group |
call-reject-no-resource | call-setup | call-setup-failure |
cpu-available-memory | cpu-load | cpu-orbs-crit | cpu-orbs-warn |
cpu-session-throughput | cpu-utilization | cscf-service-route-failures |
dereg-reply-error | fa-reg-reply-error | fw-deny-rule | fw-dos-attack |
fw-drop-packet | fw-no-rule | ha-init-rrq-rcvd-rate |
ha-svc-init-rrq-rcvd-rate| ip-pool-free | ip-pool-hold | ip-pool-release |
ip-pool-used | ipsec-call-req-rej | ipsec-ike-failrate | ipsec-ike-failures
| ipsec-ike-requests | ipsec-tunnels-established | ipsec-tunnels-setup |
license-remaining-session | mgmt-cpu-memory-usage interval |
mgmt-cpu-utilization | packets-filtered-dropped | packets-forwarded-to-cpu
| pdif-current-sessions | pdif-current-active-sessions |
pdsn-init-rrq-rcvd-rate | per-service-ggsn-sessions |
per-service-ha-sessions | per-service-lns-sessions |
per-service-pdsn-sessions | per-service-sgsn-sessions |
per-service-sgsn-pdp-sessions | port-high-activity | port-rx-utilization |
port-tx-utilization | ppp-setup-fail-rate | reg-reply-error |
rereg-reply-error | rp-setup-fail-rate | storage-utilization |
total-ggsn-sessions | total-ha-sessions | total-lns-sessions |
total-pdsn-sessions | total-sgsn-sessions | total-sgsn-pdp sessions |
total-subscriber } interval time
Web Element Manager Path
This functionality is not supported at this time on the Web Element Manager.
show port table
The introduction of the Quad Gig-E line Card on the ST40 means that additional
information is available in the Redundant With... column whenever the port is used in a link
aggregation. The following is added to the Show Port Table output in the Show Command
Outputs chapter in the Counters and Statistics Reference:
information is available in the Redundant With... column whenever the port is used in a link
aggregation. The following is added to the Show Port Table output in the Show Command
Outputs chapter in the Counters and Statistics Reference:
Extra information is shown in the “Redundant With” column when the port is in a Link
Aggregation using the four-port Quad Gig-E line card (QGLC) in an ST40. It now shows
LAG and the redundant card/port detail and a + character if the port is selected and a -
character if it is not selected.
Aggregation using the four-port Quad Gig-E line card (QGLC) in an ST40. It now shows
LAG and the redundant card/port detail and a + character if the port is selected and a -
character if it is not selected.
Web Element Manager Path
This functionality is not supported at this time on the Web Element Manager.