Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
IP Pool Sharing Protocol
Configuring IPSP Before the Software Upgrade ▀
Cisco ASR 5000 Series Enhanced Feature Configuration Guide ▄
OL-22982-01
Enabling IPSP on the Secondary HA
The secondary HA is the alternate HA that is to take responsibility while the primary HA is upgraded.
Important:
This section provides the minimum instruction set for configuring IPSP on the system. For more
information on commands that configure additional parameters and options, refer to the IPSP Configuration Mode
Commands chapter in Command Line Interface Reference.
Commands chapter in Command Line Interface Reference.
Use the following example to enable the IPSP on secondary HA:
Notes:
The interface must be configured in the same context as the HA service and must be on the same network as the
primary HA‘s IPSP interface.
is the name of the interface on which you want to enable IPSP.
dead-interval is an optional command to configure time to wait before retrying the primary HA for the IP Pool
Sharing Protocol.
Enabling IPSP on the Primary HA
The primary HA is the HA that is to be upgraded.
Important:
This section provides the minimum instruction set for configuring IPSP on the system. For more
information on commands that configure additional parameters and options, refer to the IPSP Configuration Mode
Commands chapter in the Command Line Interface Reference.
Commands chapter in the Command Line Interface Reference.
Use the following example to enable the IPSP on primary HA: