Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas

Página de 580
  Session Recovery 
Configuring the System to Support Session Recovery  ▀   
Cisco ASR 5000 Series Enhanced Feature Configuration Guide  ▄  
 
  OL-22983-01 
 
Viewing Recovered Session Information 
Per subscriber session information is available to show any changes in session recovery status. A new field has been 
added to the show subscriber debug-info command that is named ―Redundancy Status‖. This field shows whether or not 
the session has been recovered or is the original information. There are two valid outputs for this field: 
 
 
Original - indicating that this is the original session information, containing all event states and time 
information. 
 
Recreated Session - indicating that this session was reconstructed during a session recovery operation. 
This command can be executed before or after a session recovery operation has been performed, and would show 
information relative to the specific session. 
To view session state information and any session recovery status, enter the following command: 
 
Keyword/Variable
 
Description
 
 
Displays subscriber information for the call specified by 
. The call ID must be specified as an 8-byte 
hexadecimal number. 
 
Displays information for the mobile user identified by 
 must be from 7 to 16 digits specified as an 
IMSI, MIN, or RMI. Wildcard characters $ and * are allowed. The * wildcard matches multiple characters and 
the $ wildcard matches a single character. If you do not want the wildcard characters interpreted as a wildcard 
enclose them in single quotes ( ‗ ). For example; ‗$‘. 
 
 
Displays information for connections for the subscriber identified by 
. The user must have ben 
previously configured. 
 must be a sequence of characters and/or wildcard characters ('$' and '*') from 1 
to 127 characters in length. The * wildcard matches multiple characters and the $ wildcard matches a single 
character. If you do not want the wildcard characters interpreted as wildcard enclose them in single quotes ( ‗). 
For example; ‗$‘. 
 
The following example shows the output of this command both before and after a session recovery operation has been 
performed. The ―Redundancy Status‖ fields in this example have been bold-faced for clarity.