Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Service Configuration Procedures
Creating and Configuring HA Services ▀
Cisco ASR 5000 Series Packet Data Serving Node Administration Guide ▄
OL-22939-01
Creating and Configuring HA Services
HA services are configured within contexts and allow the system to function as an HA in the 3G wireless data network.
Important:
This section provides the minimum instruction set for configuring an HA service that allows the
system to process data sessions. Commands that configure additional HA service properties are provided in the
Command Line Interface Reference. Additionally, when configuring Mobile IP take into account the MIP timing
considerations discussed in MIP Timer Considerations .
Command Line Interface Reference. Additionally, when configuring Mobile IP take into account the MIP timing
considerations discussed in MIP Timer Considerations .
Use this example to create and/or configure HA services:
Following are a few things to be aware of:
The
command configures the User Datagram Protocol (UDP) port for the Pi interfaces‘ IP
socket.
A maximum of 2048 FA-HA SPIs can be configured for each HA service.
An infinite registration lifetime can be configured using the
command.
The hardware configuration and features installed can affect the maximum subscriber sessions that can be
supported.
Optionally configure the HA service for controlling the negotiation and sending of the I-bit in revocation
messages by adding the
comand. By default it will not send I-bit in
recocation message.
Optionally change the maximum amount of time, in seconds, allowed to set up a session. The default setting is
60 seconds. To change this value add the
command.
Repeat the configuration as needed to create and bind additional HA services to any other interfaces.