Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Serving Gateway Configuration
Configuring the System as a Standalone eGTP S-GW ▀
Cisco ASR 5000 Series Serving Gateway Administration Guide ▄
OL-22986-01
Required
Information
Information
Description
Gateway IP address
Used when configuring static IP routes from the management interface(s) to a specific network.
Security
administrator name
administrator name
The name or names of the security administrator with full rights to the system.
Security
administrator
password
administrator
password
Open or encrypted passwords can be used.
Remote access
type(s)
type(s)
The type of remote access that will be used to access the system such as telnetd, sshd, and/or ftpd.
Required S-GW Ingress Context Configuration Information
The following table lists the information that is required to configure the S-GW ingress context on an eGTP S-GW.
Table 4. Required Information for S-GW Ingress Context Configuration
Required
Information
Description
S-GW ingress
context name
context name
An identification string from 1 to 79 characters (alpha and/or numeric) by which the S-GW ingress context is
recognized by the system.
recognized by the system.
Accounting
policy name
policy name
An identification string from 1 to 63 characters (alpha and/or numeric) by which the accounting policy is
recognized by the system. The accounting policy is used to set parameters for the Rf (off-line charging)
interface.
recognized by the system. The accounting policy is used to set parameters for the Rf (off-line charging)
interface.
S1-U/S11 Interface Configuration (To/from eNodeB/MME)
Interface name
An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface is
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
IP address and
subnet
subnet
IPv4 or IPv6 addresses assigned to the interface.
Multiple addresses and subnets are needed if multiple interfaces will be configured.
Multiple addresses and subnets are needed if multiple interfaces will be configured.
Physical port
number
number
The physical port to which the interface will be bound. Ports are identified by the chassis slot number where
the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
Gateway IP
address
address
Used when configuring static IP routes from the interface(s) to a specific network.
GTP-U Service Configuration
GTP-U service
name
name
An identification string from 1 to 63 characters (alpha and/or numeric) by which the GTP-U service will be
recognized by the system.
recognized by the system.