Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
System Element Configuration Procedures
Creating and Configuring Frame Relay Interfaces and Ports ▀
Cisco ASR 5000 Series System Administration Guide ▄
OL-22969-02
Make a note of the information you configure - you will need it again later for the
command used to
configure channel characteristics.
The default
is SONET for the channelized line card.
With releases 8.1 and higher, we recommend that you include the signal type, either
or
, when defining
the framing.
With releases 8.1 and higher, you need to set the
for the CLC card to
, all
other options are not fully supported at this time.
Configuring the Channel Characteristics
Use the following example to configure the path, framing, mapping, timeslots, and the Frame Relay interface and LMI
characteristics for a specific CLC port:
characteristics for a specific CLC port:
Important:
You should make a record of the path definition values you enter as the information will be needed
again with other configuration commands.
Binding a DLCI
Use the following procedure to bind the DLCI to the channelized (Frame Relay) port.
Important:
This procedure should not be attempted until after the configuration is completed for Peer-NSEIs
and/or SS7 routing domains as described in the SGSN Administration Guide.