Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Troubleshooting the System
Taking Corrective Action ▀
Cisco ASR 5000 Series System Administration Guide ▄
OL-22969-02
Check the entry in the Oper State column next to the PAC/PSC that was just migrated from. Its state should
be Standby. The state of the PAC/PSC migrated to should be Active.
be Standby. The state of the PAC/PSC migrated to should be Active.
Manually Initiating a Line Card Switch
Line cards are installed in the half-height slots at the rear of the chassis. This design allows for two line cards (both
Ethernet 10/100 both Ethernet 1000 (or both QGLCs on an ASR 5000)) to be installed behind every application card.
When two line cards are installed, as the application card that they are installed behind is booted, the card in the upper-
rear chassis slot will automatically be made active while the card in the lower-rear chassis slot will automatically be
placed in standby mode. In the event that the active card experiences a failure, the system will automatically switch
traffic to the standby card in the lower slot.
Ethernet 10/100 both Ethernet 1000 (or both QGLCs on an ASR 5000)) to be installed behind every application card.
When two line cards are installed, as the application card that they are installed behind is booted, the card in the upper-
rear chassis slot will automatically be made active while the card in the lower-rear chassis slot will automatically be
placed in standby mode. In the event that the active card experiences a failure, the system will automatically switch
traffic to the standby card in the lower slot.
In the event that a SPIO experiences a failure, the system will automatically switch traffic to the redundant SPIO
installed behind the redundant SPC/SMC.
installed behind the redundant SPC/SMC.
In the event that an issue arises that is not severe enough for the system to perform an automatic switch, a manual switch
can be performed. Follow the instructions below to manually initiate a line card or SPIO switch. These instructions
assume you are at the root prompt for the Exec mode:
can be performed. Follow the instructions below to manually initiate a line card or SPIO switch. These instructions
assume you are at the root prompt for the Exec mode:
Step 1
Initiate a manual line card or SPIO migration by entering the following command:
Keyword/Variable
Description
lc
Specifies that a switch will be done for an Ethernet 10/100 or Ethernet 1000 Line Card (Quad Gig-E (QGLC)
on an ASR 5000 only).
on an ASR 5000 only).
spio
Specifies that a switch will be done for a SPIO.
to
Specifies the chassis slot number of the redundant Ethernet 10/100 or Ethernet 1000/QGLC Line Card that is
being migrated to. Executing this command will switch network connections from the active line card that
corresponds to the card being migrated to.
being migrated to. Executing this command will switch network connections from the active line card that
corresponds to the card being migrated to.
can be any of the following integer values: 17 through 23, 26 through 39, or 42 through 48.
Important:
This keyword is only used if the
keyword is used. The line card being
migrated to must be in the standby mode.
You will receive the following prompt: