Cisco Cisco Packet Data Gateway (PDG) Guia De Resolução De Problemas
Engineering Rules
Subscriber Rules ▀
Cisco ASR 5000 Series System Administration Guide ▄
OL-22969-02
Subscriber Rules
The following engineering rules apply to subscribers configured within the system:
Configure a maximum of 2,048 local subscribers per context.
You may configure attributes for each local subscriber.
The system creates a default subscriber default for each context when the context is made. Configure attributes
for each default subscriber. If a AAA-based subscriber is missing attributes in the authentication reply
message, the default subscriber attributes in the context where the subscriber was authenticated are used.
message, the default subscriber attributes in the context where the subscriber was authenticated are used.
Important:
Default is not used when local authentication (for local subscribers) is performed.
Configure default subscriber templates on a per AAA realm (domain aliases configured within a context) basis.
Configure default subscriber templates on a per PDSN, FA,ASN GW, or HA service.
For AAA authenticated subscribers, the selection of local subscriber template to use for setting attributes is in the
following order:
If the username (NAI) matches any local domain name and the domain name has a local subscriber
name configured, that local subscriber template is used.
If the first case fails, and if the serving service has a default username configured, that subscriber
template is used.
If the first two cases fail, the default subscriber template in the AAA context is used.