Cisco Cisco Aironet 1400 Wireless Bridge Guia Da Instalação

Cisco Aironet 1400 Series Wireless Bridge Mounting Instructions

OL-7618-01

Initial Lab Bring-Up

Step 5

Connect the dual-coax cables to the bridge and the power injector.

Step 6

Connect the AC power cord to the power module.

Step 7

Connect the power module’s AC power cord to an AC receptacle. Do not connect power to the power
injector.

Setting Each Bridge to Defaults

To set the bridge to default value, follow these steps for each bridge:

Step 1

Ensure other bridges are not powered up.

Step 2

Press and hold the power injector’s MODE button while you connect the power cable to the power jack.

Step 3

Release the MODE button when the Status LED turns amber (approximately 1 to 3 seconds) and wait
until the bridge boots up and enters Root mode (Install LED blinks green). All bridge settings return to
factory defaults.

Note

When the bridge is set to factory defaults, the bridge is placed into Install mode and the SSIDs
is set to autoinstall. This allows your bridges to automatically establish a communication link
between root and non-root bridges.

Step 4

Click Apply.

Step 5

Close your Internet browser and remove the Ethernet cable from the power injector.

Step 6

Remove the power jack from the power injector.

Configuring the Root Bridge

When setting up a bridge system, you should configure the root bridge first. A bridge configured with
factory defaults, on power up, automatically attempts to associate to a root bridge. After 60 seconds if
the bridge is unable to associate to a root bridge, it automatically becomes a root bridge.

To configure the root bridge, follow these steps:

Step 1

Ensure other bridges are not powered up.

Step 2

Connect the power jack to the power injector’s power connector.