Cisco Cisco Aironet 1310 Access Point Bridge Guia Da Instalação

Do not operate your wireless network device near unshielded blasting caps or in an explosive 
environment unless the device has been modified to be especially qualified for such use. 
Statement 245B

In order to comply with international radio frequency (RF) exposure limits, dish antennas should be 
placed at a minimum of 8.7 inches (22 cm) from the bodies of all persons. Other antennas should be 
placed a minimum of 7.9 inches (20 cm) from the bodies of all persons. Statement 246

Do not work on the system or connect or disconnect cables during periods of lightning activity. 
Statement 1001

This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that 
the protective device is rated not greater than: 15A 
Statement 1005

This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the 
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection 
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Ultimate disposal of this product should be handled according to all national laws and regulations. 
Statement 1040

Do not locate the antenna near overhead power lines or other electric light or power circuits, or 
where it can come into contact with such circuits. When installing the antenna, take extreme care 
not to come into contact with such circuits, as they may cause serious injury or death. For proper 
installation and grounding of the antenna, please refer to national and local codes (e.g. U.S.:NFPA 70, 
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54). 
Statement 1052

The following warning applies to outdoor and DC power source installations:

Only trained and qualified personnel should be allowed to install, replace, or service this equipment. 
Statement 1030