Cisco Cisco Aironet 1524 Lightweight Outdoor Mesh Access Point
34
Mobile Access Router and Mesh Networks Design Guide
OL-11823-01
Using the MAR3200 in Mobile Environments
Configuring the Mobile Router (MR)
Perform the following steps to configure the MAR as a MR for use in a Mobile IP network:
Step 1
Log in to the MR.
Step 2
Enter either of the following commands to determine the current configuration of the MR:
MR# show ip mobile globals
MR# show running-configure
Step 3
Enable MoIP on the MR. Enable mobile route and configure the MoIP variable globally including HA
information. From the router’s global configuration mode, enter the following commands:
information. From the router’s global configuration mode, enter the following commands:
MR(config)# router mobile
MR(config)# ip mobile router
MR(mobile-router)# address
mobile router loopback address
255.255.255.255
MR(mobile-router)# home-agent 10.10.10.1
Enter the exit command to exit from Mobile Router mode.
Enter:
MR(config)#ip mobile secure home-agent 10.10.10.1 spi
SPI number from table
key hex s
tring
from table
Note
The SPI number and string must match those you entered for the HA exactly or the tunnel and
the mobile connection will not come up.
the mobile connection will not come up.
Step 4
Enable MoIP on MR. Enable mobile route and configure MoIP variable globally including HA
information:
information:
MR(config)# interface vlan 2
MR(config-if)#ip mobile router-service roam
MR(config-if)#ip mobile router-service solicit interval 5
Step 5
Enter the show ip mobile router command to verify your configuration.
Verifying the Mobile IP Configuration
To verify the Mobile IP configuration, perform the following steps from the MR:
Step 1
To view the advertisements from the FAs, enter:
MR# debug ip icmp
Step 2
To verify that your MR is receiving advertisements from one FA, enter:
MR# show ip mobile router agent
Is your MR sending IRDP solicitations?
Step 3
To verify that the MR has associated with the HA, and that the tunnels are up, enter:
MR# show ip mobile router
Step 4
Log into that FA and examine the operation of the FA using the following commands:
FA# show ip mobile global