Cisco Cisco Packet Data Gateway (PDG) Guia Do Administrador

Página de 308
Gx Interface Support   
▀  Rel. 8 Gx Interface 
 
 
▄  Cisco ASR 5x00 Home Agent Administration Guide 
152 
   
For each request from the PCEF or upon unsolicited provisioning, the PCRF provisions zero or more PCC rules. The 
PCRF may perform an operation on a single PCC rule by one of the following means: 
 
To activate or deactivate a PCC rule that is predefined at the PCEF, the PCRF provisions a reference to this PCC 
rule within a Charging-Rule-Name AVP and indicates the required action by choosing either the Charging-
Rule-Install AVP or the Charging-Rule-Remove AVP. 
 
To install or modify a PCRF-provisioned PCC rule, the PCRF provisions a corresponding Charging-Rule-
Definition AVP within a Charging-Rule-Install AVP. 
 
To remove a PCC rule which has previously been provisioned by the PCRF, the PCRF provisions the name of 
this rule as value of a Charging-Rule-Name AVP within a Charging-Rule-Remove AVP. 
Important:
  In 11.0 and later releases, the maximum valid length for a charging rule name is 63 bytes. When the 
length of the charging rule name is greater than 63 bytes, a charging rule report with RESOURCES_LIMITATION as 
Rule-Failure-Code is sent. This charging rule report is sent only when the length of the rule name is lesser than 128 
characters. When the charging rule name length is greater than or equal to 128 characters no charging rule report will be 
sent. In earlier releases, the length of the charging rule name constructed by PCRF was limited to 32 bytes. 
Releases prior to 14.0, when PCRF has subscribed to Out of Credit trigger, on session connect when one rule validation 
fails and also when an Out of Credit was received from OCS for another rule, P-GW was trying to report these failures 
in different CCR-U to PCRF. However, the second CCR-U of Out of credit was getting dropped internally. 
In 14.0 and later releases, on session connect, P-GW combines the rule failure and out of credit in the same CCR-U and 
sends to PCRF. 
Selecting a PCC Rule for Uplink IP Packets
 
If PCC is enabled, the PCEF selects the applicable PCC rule for each received uplink IP packet within an IP-CAN 
session by evaluating the packet against uplink SDF filters of PCRF-provided or predefined active PCC rules of this IP-
CAN session in the order of the precedence of the PCC rules. 
Important:
  When a PCRF-provided PCC rule and a predefined PCC rule have the same precedence, the uplink 
SDF filters of the PCRF-provided PCC rule is applied first. 
When a packet matches an SDF filter, the packet matching process for that packet is completed, and the PCC rule for 
that filter is applied. Uplink IP packets which do not match any PCC rule of the corresponding IP-CAN session are 
discarded. 
Selecting a PCC Rule for Downlink IP Packets
 
If PCC is enabled, the PCEF selects a PCC rule for each received downlink IP packet within an IP-CAN session by 
evaluating the packet against downlink SDF filters of PCRF-provided or predefined active PCC rules of the IP-CAN 
session in the order of precedence of the PCC rules. 
Important:
  When a PCRF-provided PCC rule and a predefined PCC rule have the same precedence, the 
downlink SDF filters of the PCRF-provided PCC rule are applied first. 
When a packet matches an SDF filter, the packet matching process for that packet is completed, and the PCC rule for 
that filter is applied. Downlink IP packets that do not match any PCC rule of the IP-CAN session are discarded. 
The following procedures are also supported: