Cisco Cisco Packet Data Gateway (PDG) Folheto
show port
show port table ▀
Cisco ASR 5x00 Statistics and Counters Reference ▄
3763
show port table
Table 448.
show port table
Command Output Descriptions
Field
Description
Port
Specifies the chassis slot and port numbers (<slot>/<port>) for all installed line cards.
Role
The communication role played by this port.
Mgmt: Port has been designated for remote management access.
Srvc: Port handles subscriber traffic.
Type
The card type descriptor.
Admin
Indicates whether or not the card has been configured for use via software. If it has been configured, Enabled
will be displayed. If not, Disabled will be displayed.
will be displayed. If not, Disabled will be displayed.
Oper
The operational state of the card – Up or Down.
Link
The link status – Up or Down.
State
The operational mode of the card that the port belongs to. The card can be in one of the following modes:
Active: Indicates that the card is an active component that will be used to process subscriber data
sessions.
sessions.
Standby: Indicates that the card is a redundant component. Redundant components will become
active through manual configuration or automatically should a failure occur.
active through manual configuration or automatically should a failure occur.
Offline: Indicates that the card is installed but is not ready to process subscriber data sessions. This
could be because it is not completely installed (for example. the card interlock switch is not locked).
Refer to the Installation Guide for additional information.
could be because it is not completely installed (for example. the card interlock switch is not locked).
Refer to the Installation Guide for additional information.
Pair
The redundant port for that port. If a redundant port is not available, None will be displayed.
Extra information is shown in the “Redundant” column when the port is in a link aggregation group. It now
shows “LAG” and the redundant card/port detail.
Extra information is shown in the “Redundant” column when the port is in a link aggregation group. It now
shows “LAG” and the redundant card/port detail.
Redundant
An aggregated port can be selected and collecting data, and either distributing data or not distributing data.
If the port is distributing data, a “+” sign appears in the port detail next to the “LAG” entry. If the port is not
distributing data, then a “-” sign appears instead.
If the port is distributing data, a “+” sign appears in the port detail next to the “LAG” entry. If the port is not
distributing data, then a “-” sign appears instead.
Untagged:
Indicates the administrative, operational, link and active/standby states of an untagged (non-VLAN) port.
Tagged: VLAN
<vlan_id>
<vlan_id>
Indicates the administrative, operational, link and active/standby states of a VLAN port.