Cisco Cisco WAP4410N Wireless-N Access Point - PoE Advanced Security
4
Release Notes for WAP4410N Access Point Firmware Version 2.0.6.1
Release Notes
•
CSCtz05386—When enabling IPv6, the link local is not displayed on the
status page. Workaround: SSH into the device and execute an ifconfig to
determine the link local.
status page. Workaround: SSH into the device and execute an ifconfig to
determine the link local.
•
CSCtz79116—The MAC Connection Control List allows empty entries to
be saved. Enabling MAC Control and not specifying MAC addresses may
disconnect your clients.
be saved. Enabling MAC Control and not specifying MAC addresses may
disconnect your clients.
•
CSCtz79129—The AP mode appears incorrectly as G when the AP is
selected to work in N-only mode.
selected to work in N-only mode.
•
CSCts76476—The access point may periodically experience loss of
connectivity when configured in bridge mode. Workaround: Unplug the
power adaptor or PoE cable, and then plug it back in.
connectivity when configured in bridge mode. Workaround: Unplug the
power adaptor or PoE cable, and then plug it back in.
•
CSCtx62203—In certain environments and traffic model, the WAP4410N
may lockup after some undetermined time. Workaround: Reboot the
device.
may lockup after some undetermined time. Workaround: Reboot the
device.
•
CSCtz05399—The WAP4410N displays only one IPv6 address when set
to IPv6 autoconfiguration. For example, if the router is advertising multiple
prefixes, a local (fec0::) and a global site (2001::), the access point only
acquires one of the two addresses.
to IPv6 autoconfiguration. For example, if the router is advertising multiple
prefixes, a local (fec0::) and a global site (2001::), the access point only
acquires one of the two addresses.
•
CSCtz59478—When enabling or disabling the VLAN or QoS features, your
Internet connection will be lost. Workaround: After configuring the VLAN or
QoS features, unplug the power adaptor or PoE cable, and then plug it back
in.
Internet connection will be lost. Workaround: After configuring the VLAN or
QoS features, unplug the power adaptor or PoE cable, and then plug it back
in.
Notes
•
When using the WPS feature and you are still using the default SSID of
ciscosb, the system automatically changes the ciscosb SSID to Network-
"MAC-ADDRESS" for security purposes. If you prefer to retain your SSID
and use WPS at the same time, configure a unique SSID before invoking
WPS.
ciscosb, the system automatically changes the ciscosb SSID to Network-
"MAC-ADDRESS" for security purposes. If you prefer to retain your SSID
and use WPS at the same time, configure a unique SSID before invoking
WPS.
•
The WAP4410N now has a Setup Wizard to aid in initial configuration.
•
The WPS PIN-External Register mode stops attempting to register a client
after 30 failed attempts.
after 30 failed attempts.