Cisco Cisco Packet Data Gateway (PDG)
Troubleshooting
Taking Corrective Action ▀
ASR 5000 System Administration Guide, StarOS Release 16 ▄
221
Initiate a Card Halt
Follow the instructions below to manually initiate a card halt. These instructions assume you are at the root prompt for
the Exec mode:
the Exec mode:
[local]host_name#
Step 1
Initiate a manual card migration by entering the following command:
card halt slot#
slot#
is the chassis slot number in which the card to be halted is installed. It can be any integer value between 1 and 7,
10 through 48. You will receive the following prompt:
Are You Sure? [Yes|No]:
Step 2
Press
Y
to initiate the halt operation.
Step 3
Verify that the migration was successful by entering the following command at the prompt:
show card table
Check the entry in the Oper State column next to the line card that was just halted. Its state should be Offline. If the card
was in active mode prior to the execution of this command, the state of the redundant component associated with it
should now be Active.
was in active mode prior to the execution of this command, the state of the redundant component associated with it
should now be Active.
Restoring a Previously Halted Card
Follow the instructions below to restore a card that was previously halted. These instructions assume you are at the root
prompt for the Exec mode:
prompt for the Exec mode:
[local]host_name#
Step 1
Reboot the card to be restored by entering the following command.
card reboot slot# -force
You will receive the following prompt:
Are You Sure? [Yes|No]:
Step 2
Press
Y
to start the reboot of the card.
Step 3
Verify that the migration was successful by entering the show card table command at the prompt.
Check the entry in the Oper State column next to the line card that was just restored. Its state should be the state of that
it was in before it was halted.
it was in before it was halted.