Cisco Cisco Packet Data Gateway (PDG)
tethering-detection
This command allows you to define rule expressions to match tethered or non-tethered flows.
Product
ACS
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-acs-ruledef)#
Syntax Description
tethering-detection [ ip-ttl | os-ua ] { flow-not-tethered | flow-tethered }
no tethering-detection
no tethering-detection
no
Deletes the tethering detection configuration from the ruledef.
ip-ttl
Specifies to select flows that were tethered or non-tethered as per IP-TTL values.
os-ua
Specifies to select flows that were tethered or non-tethered as per OS-UA lookups.
In 18 and later releases, IPv6 OS-based tethering detection is supported.
flow-not-tethered
Specifies to match if tethering is not detected on flow.
flow-tethered
Specifies to match if tethering is detected on flow.
Usage Guidelines
Use this command to define rule expressions to match tethered/non-tethered flows.
Note that in order for the rule containing the tethering-detection configuration to get matched, at least one
valid rule line has to be present in it.
valid rule line has to be present in it.
Command Line Interface Reference, Modes A - B, StarOS Release 19
1277
ACS Ruledef Configuration Mode Commands
tethering-detection