Cisco Cisco Packet Data Gateway (PDG)
ignore-alt-config
Configures preference to APN/AAA-defined behavior/parameters. If the parameters are not defined in
APN/AAA, they will not be provisioned from any other source/configuration in the system, even if they are
available there.
APN/AAA, they will not be provisioned from any other source/configuration in the system, even if they are
available there.
Product
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-apn)#
Syntax Description
[ no ] ignore-alt-config { no-dns | no-s6b }
no
Disables DNS server address preference or S6b authentication on a per-APN level.
no-dns
Gives preference to DNS server address configured in APN. If name server addresses is not found in APN
configuration, it will not be provisioned from SGi context, even if it is configured there.
configuration, it will not be provisioned from SGi context, even if it is configured there.
no-s6b
Enables/disables S6b authentication on a per-APN level.
Ignores alternate service-level configuration for S6b authorization when S6b authorization is disabled at APN.
Usage Guidelines
Use this command to enable/disable DNS server address preference or S6b authentication on a per-APN level.
Configuration in APN will take precedence over configuration in P-GW service configuration.
Important
Command Line Interface Reference, Modes A - B, StarOS Release 19
1606
APN Configuration Mode Commands
ignore-alt-config