Cisco Cisco Packet Data Gateway (PDG)
firewall policy
This command allows you to enable/disable Stateful Firewall support for all subscribers using the current
rulebase.
rulebase.
In StarOS 8.0, this command is available in the APN/Subscriber Configuration Mode. In StarOS 8.1 and
StarOS 8.3, use this command for Rulebase-based Firewall-and-NAT configuration. In StarOS 8.1 and
StarOS 9.0 and later releases, for Policy-based Firewall-and-NAT configuration, this command is available
in the Firewall-and-NAT Policy Configuration Mode.
StarOS 8.3, use this command for Rulebase-based Firewall-and-NAT configuration. In StarOS 8.1 and
StarOS 9.0 and later releases, for Policy-based Firewall-and-NAT configuration, this command is available
in the Firewall-and-NAT Policy Configuration Mode.
Important
Product
PSF
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-rule-base)#
Syntax Description
firewall policy firewall-required
{ default | no } firewall policy
{ default | no } firewall policy
default
Configures this command with its default setting.
Default: Stateful Firewall support is disabled for all subscribers using the current rulebase.
no
If previously enabled, disables Stateful Firewall support for all subscribers using the current rulebase.
firewall-required
Enables Stateful Firewall support for all subscribers using the current rulebase.
Usage Guidelines
Use this command to enable/disable Stateful Firewall support for all subscribers using the current rulebase.
Command Line Interface Reference, Modes A - B, StarOS Release 19
663
ACS Rulebase Configuration Mode Commands
firewall policy