Cisco Cisco Packet Data Gateway (PDG)
rtp dynamic-flow-detection
This command allows you to enable/disable the Real Time Streaming Protocol (RTSP) and Session Description
Protocol (SDP) analyzers to detect the start/stop of RTP and RTCP flows.
Protocol (SDP) analyzers to detect the start/stop of RTP and RTCP flows.
Product
ACS
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-rule-base)#
Syntax Description
[ default | no ] rtp dynamic-flow-detection
default
Configures this command with its default setting.
Default: Disabled; same as no rtp dynamic-flow-detection.
no
If previously configured, deletes this configuration from the current rulebase.
Usage Guidelines
Use this command to enable the RTSP and SDP analyzer to detect the start/stop of RTP and RTCP flows.
This command is used in conjunction with the route priority command.
This command is used in conjunction with the route priority command.
Examples
The following command enables RTP dynamic flow detection:
rtp dynamic-flow-detection
rtp dynamic-flow-detection
Command Line Interface Reference, Modes A - B, StarOS Release 19
717
ACS Rulebase Configuration Mode Commands
rtp dynamic-flow-detection