Cisco Cisco Packet Data Gateway (PDG)
tcp proxy-mode
This command allows you to enable/disable TCP Proxy mode for all subscribers using the current rulebase.
Product
ACS
CF
MVG
TPO
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-rule-base)#
Syntax Description
tcp proxy-mode { dynamic { all | content-filtering | dcca | ip-readdressing | nexthop-readdressing |
xheader-insert } + | static [ port [ port_number [ to port_number ] ] ] }
default tcp proxy-mode
no tcp proxy-mode [ dynamic { content-filtering | dcca | ip-readdressing | nexthop-readdressing |
xheader-insert } + | static [ port [ port_number [ to port_number ] ] ] ]
xheader-insert } + | static [ port [ port_number [ to port_number ] ] ] }
default tcp proxy-mode
no tcp proxy-mode [ dynamic { content-filtering | dcca | ip-readdressing | nexthop-readdressing |
xheader-insert } + | static [ port [ port_number [ to port_number ] ] ] ]
default
Configures this command with its default setting.
Default: Disabled
no
If previously enabled, disables TCP Proxy mode.
Optionally, TCP Proxy can be disabled for specific options that were previously enabled.
dynamic { all | content-filtering | dcca | ip-readdressing | nexthop-readdressing | xheader-insert } +
Enables TCP proxy for subscriber-initiated TCP flows under the specified condition(s).
• all: Specifies that subscriber-initiated TCP flows be proxied if all/any of the following conditions are
satisfied.
Command Line Interface Reference, Modes A - B, StarOS Release 19
730
ACS Rulebase Configuration Mode Commands
tcp proxy-mode